ExtNeon
ExtNeon
/ Custom end code
Last active
June 26, 2025 00:49
New version of the config file for klipper that i use with my Ender 3 4.2.2; I installed a few modifications that may and will make this config unapropriate for your machine, so use it wisely. P.S. Gist name is something.
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| ; Ender 3 Custom End G-code | |
| END_PRINT | |
| ; End of custom end GCode |
ExtNeon
/ kipper-ender3-4.2.2-bltouch-g29-g2-g3.cfg
Last active
June 23, 2025 16:41
— forked from neoyagami/kipper-ender3-4.2.2-bltouch-g29-g2-g3.cfg
Klipper config, ender 3 with 4.2.2 board (the noisy one)
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| CONFIG WAS UPDATED - SEE COMMENTS | |
| DEPRECATED | |
| # This file contains pin mappings for the NON stock 2020 Creality Ender 3 | |
| # with the 32-bit Creality 4.2.2 board. To use this config, during | |
| # "make menuconfig" select the STM32F103 with a "28KiB bootloader" and | |
| # serial (on USART1 PA10/PA9) communication. | |
| # adapted for my printer ender3-4.2.2 with some modifications and without the BLTouch. | |
| # If you prefer a direct serial connection, in "make menuconfig" |