Last active
September 4, 2025 23:13
-
-
Save utlandr/c3dab6bbcca1fc19dfc402d81cfd75e4 to your computer and use it in GitHub Desktop.
Klipper probe config for the BIQU Microprobe (V1/V2)
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
| ## --- BIQU Microprobe Klipper configuration --- | |
| # Not much different from a standard probe config. The | |
| # main difference compared to most probes is to disable | |
| # deactivating the probe (PROBE_UP) after each sample | |
| # | |
| # You can either copy pasta this directly or import | |
| # into your config.yml using [include microprobe.cfg] | |
| # | |
| # Note: if you are changing from a bltouch or one of its | |
| # clones, remove/comment out the [bltouch] config! | |
| # That also includes any auto generated config stored | |
| # at the bottom by the PROBE_CALIBRATE command | |
| # | |
| # Note: the current control and sensor pin values are | |
| # configured for the 'BTT SKR E3 mini V2' controller | |
| # board. You may need to update these values depending | |
| # on your controller board model. | |
| # | |
| # Update (2023-10-17): This config is configured for | |
| # the V1 microprobe. V2 users must update the | |
| # polarity of the sensor pin in the config to be | |
| # pull-down (^!) not pull up (^) | |
| [gcode_macro PROBE_DOWN] | |
| gcode: | |
| SET_PIN PIN=probe_enable VALUE=1 | |
| [gcode_macro PROBE_UP] | |
| gcode: | |
| SET_PIN PIN=probe_enable VALUE=0 | |
| [output_pin probe_enable] | |
| pin: PA1 # Set to the control pin on your board | |
| value: 0 | |
| [probe] | |
| pin: ^PC14 # NOTE FOR V2 users: Set this to ^!PC14 to set the low level trigger | |
| deactivate_on_each_sample: False | |
| x_offset: -40 | |
| y_offset: -35 | |
| z_offset: 0 # Will be overridden when you do a PROBE_CALIBRATE | |
| samples: 2 | |
| samples_tolerance: 0.05 | |
| samples_tolerance_retries: 3 | |
| activate_gcode: | |
| PROBE_DOWN | |
| G4 P500 | |
| deactivate_gcode: | |
| PROBE_UP |
Author
sorry, my macros are in a separate config file. I was able to get it to work by putting a 10k pulldown resistor on the servo line, Gpio 29 for the pico.
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Nice!